產品簡介ⅠDeion

山維鴻遠K11柔韌型防水涂料是以丙烯酸酯乳液和多種添加劑組成的有機液料，并以特種水泥及多種填充料組成的無機粉料，經一定比例配制成的雙組份水性防水涂料。涂刷于基體表面，固化后可形成柔韌、高強的防水涂膜。適用于衛生間、廚房、陽臺、樓地面、水池、地下室的防水、防潮。

Shanwei Hongyuan K11 flexible waterproof coating is d on high-quality acrylic emulsion and a variety of additives consisting of organic Liquid materials, and special cement and a variety of filler material composed of inorganic powder,a certain percentage of the preparation of the two-componentWater - d waterproof coating. Brush on the substrate surface, after curing can form a
flexible, high-strength waterproof coating. Applicable to   Bathroom, kitchen, balcony, floor, floor, pool, ment waterproof, moisture-proof.

注意事項ⅠPrecautions

●施工時氣溫應在5℃-35℃之間，大風或雨雪天室外禁止施工；

●配制好的涂料應在1小時內使用完畢，使用過程中嚴禁加水；

●開封后未使用完的液料或粉料，應密封貯存；

●施工過程中注意保護防水涂膜不受破壞。

● Preparation of a good paint should be completed within 1 hour after the completion of the use of the process is strictlyprohibited water;

● configured paint should be fully used within 1 hour is completed, the use of  water is strictly prohibited during the process;

● After unsealing, unused liquid or powder material should be sealed and stored.

● During the construction, pay attention to protect the waterproof coating from damage.

配比及用量ⅠRatio and Coverage

液料：粉料=10：25（重量比）；1mm厚的涂膜約需涂料2kg/m2

Liquid material: powder = 10: 25 (weight ratio); 1mm thick film about 2kg / m2

施工要點ⅠApplication Instruction

●清理基層至平整、堅實；

●一袋液料配一袋粉料，先將液料倒入攪拌桶中，在攪拌的同時緩緩加入粉料，用電動攪拌器攪拌至均勻、無結塊；

●先將基層潤濕飽和但無明水，防水涂膜宜涂刷兩至三遍，每遍涂膜干燥后方可進行下道工序，時間間隔4-6小時。待涂膜干燥后，方可進行閉水試驗；

●防水層涂膜厚度宜1.5-2.0mm；施工時宜采用“十”字交叉涂刷的方式。

● clean up the grassroots level to a solid, solid;

● a bag of liquid with a bag of powder, the first liquid into the mixing tank, while stirring slowly adding powder, Stir with an electric stirrer to uniform, without  agglomeration;

● first wetting saturated but no water, waterproof coating should be painted two to three times, each time the coating is dry before The next process, the time interval of 4-6 hours. Until the coating is completely dry before the closed water test;

● waterproof coating thickness should be 1.5-2.0mm; construction should use "ten" word cross brushing way.

產品貯存ⅠStorage

存放于陰涼干燥處；在5℃-35℃正常運輸條件下，未啟封產品保質期為12個月。

Store in a cool dry place; in 5 ℃ -35 ℃ under normal transport

conditions, nopened product shelf life of 12 months.

執行標準ⅠProduct standard

GB/T23445-2009《聚合物水泥防水涂料》

GB/T23445-2009 "Polymer cement waterproof coating"

生產日期和批號ⅠProduction  date and Batch number

見合格證。See the certificate.